Toro EVOLUTION Series SOIL SENSOR Manual de Instalação

Specifications• Power Supply: 4.5 VDC supplied by three size-AA alkaline batteries• Housing Material: High-impact, UV-resistant ABS • Moisture Prot

104. Press to CALIBRATE. to START. to conrm.5. START will turn to CANCEL. Over the specied time period (see note above), the soil sensor wil

11Review Screene Review screen allows operators to review settings for the various sensors added to the controller.1. Press the Review button.2.

12Appendix B: Site Selection and Earth InstallationSite SelectionChoosing the right location for the sensor is important for the overall eectiveness

13! For close-cut turf varieties, such as Hybrid Bermuda, the top of the sensor must be installed at grade level to prevent damage by mowing equipment

14Toro Commitment to QualityToro is committed to developing and producing the highest quality, best performing, most dependable products on the market

2Specications 1Overview 3Installation 4 EVOLUTION® Smart Connect® 4 Precision™ Soil Sensor 4 Battery Installation 4Sensor Setu

3e Precision™ Soil Sensor Add-On works with the EVOLUTION® Smart Connect® receiver. It is possible to add up to three soil sensors per controller. O

4EVOLUTION® Smart Connect®Precision™ Soil SensorBattery Installatione Soil Sensor works on three “AA” Alkaline or Lithium batteries (not included).1.

5Sensor SetupImplement the following two procedures to successfully setup Toro’s Precision™ Soil Sensor:1. “Add” the sensor to the controller for suc

65. e controller will detect the soil sensor. Conrm that the sensor ID detected matches the sensor’s SN ID.6. If it does match, press and contin

7calibration will be set using the next sensor reading (within 30 minutes).Additional calibration settings are available. From ‘1’ (~1 day “watch wind

83. Press to select the desired soil sensor. 4. To add a sensor to a schedule: Press or to select the desired Schedule (A, B, or C).Press o

9Fine-tuning the “Low reshold” Moisture LevelChanges to the 50% setting should be made initially in 5% increments in order to see results within a fe