Toro SitePro Central Control Guia de Configuração descarregar pdf (Página 18)

STEP 5:

PROGRAM THE

CONTROL SYSTEM

Once the control system and hydraulic

system have been defined, you can set

up irrigation programs.

➊ Name the irrigation program and

select a percent adjustment (if

desired) (Setup > Programs)

➋ Select the schedule mode for the

program (Setup > Programs >

Schedule)

Choose from 14-day Calendar,

Interval, Odd Days, Even Days or Annual Calendar.

➌ Assign the active days for the program (Setup > Programs > Active Days)

Set the active days if either the 14-Day Calendar or Annual Calendar mode has been

selected. Once set, the active days on the calendar turn bright green.

➍ Specify ET parameters and run-time calculation (Setup > Programs > ET Use)

Specify the run-time calculation method of the program, ET mode, source of ET,

reference ET and default run times.

➎ Assign repeats and soaks (Setup > Programs > Repeats/Soaks)

Select the number of repeats of the selected program and specify the minimum soak

time for stations in the program.

➏ Assign auto switches (Setup > Programs > Auto Switch)

Assign switches using the Auto Switch tab.

➐ Review program setup (Setup > Programs > Summary)

Verify the feature settings and configuration of each of your irrigation programs.

➑ Create master program sequences (Setup > Programs > Start Times > Information)

Start times are assigned to master program sequences. Go to the Information tab under

Programs > Start Times to create and name a master sequence.

➒ Assign programs to master sequences (Setup > Programs > Start Times >

System Programs)

Assign programs to specific master sequences. All programs in the system are listed.

➓ Define master sequence attributes and program modes (Setup > Programs >

Start Times > Information)

• Highlight a sequence and assign it a watering priority, percent adjustment and a start

or stop time.

• Select a program and choose a running mode: normal or syringe/test cycle.

• Click on the check box to make the program part of the master sequence.

Assign stations and review station assignment (Setup > Assign Stations)

Use the table on the Assign Stations screen to assign stations to a particular program or

select Auto Programmer to create assignments. Review stations assignments here.

— ➊ through ➓

—

SitePro Central Control System

Getting Started Manual

Initial SitePro Setup

1 2 ... 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

Toro SitePro Central Control Guia de Configuração Página 18

Comentários a estes Manuais